Carrier Access Network Device Axxius 800 Uživatelský manuál stáhnout pdf (Strana 258)

100

101

5-158 Axxius 800 - Release 2.2

CLI Commands

set

set (router-wan) nat enable/disable

Use the set (router-wan) nat command to enable and disable Network Address Translation

(NAT) on a specified WAN interface.

Syntax: set {rtr_card-addr} {"wan-name"} nat {disable|enable}

Example: set 1 "LosAngeles" nat enable

The example will set the WAN interface named "LosAngeles" on the Router

card in slot 1 to enable NAT mapping.

{rtr_card-addr}

The slot number (1-8) that contains the Router card.

{"wan-name"}

The WAN interface to modify. The name must be enclosed in quotes.

{disable|enable}

set (router-wan) nat ports

Use the set (router-wan) nat ports command to configure Network Address Translation

(NAT) to dynamically map ports or preserve them. This field should only be set to

"preserved" if an application that you are using requires a specific port number.

Syntax: set {rtr_card-addr} {"wan-name"} nat ports

{dynamic|preserved}

Example: set 1 "LosAngeles" nat ports dynamic

The example will set the WAN interface named "LosAngeles" on the Router

card in slot 1 to enable dynamic NAT port mapping.

{rtr_card-addr}

The slot number (1-8) that contains the Router card.

{"wan-name"}

The WAN interface to modify. The name must be enclosed in quotes.

{dynamic|preserved}

disable Disable NAT mapping.

enable Enable NAT mapping.

dynamic Set NAT port mapping to be dynamic.

preserved Preserve original port.

1 2 ... 253 254 255 256 257 258 259 260 261 262 263 ... 567 568

Komentáře k této Příručce

Žádné komentáře

Carrier Access Network Device Axxius 800 Uživatelský manuál Strana 258

Komentáře k této Příručce

Související produkty a manuály pro Sítě Carrier Access Network Device Axxius 800