Carrier-access Adit 3000 Series and Multi-Service Router (MSR) Ca Uživatelský manuál stáhnout pdf (Strana 269)

100

101

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 11-25

Configuration - Ethernet Interface Mode

speed

Use the Ethernet Interface speed command to specify the Ethernet PHY (physical specifications) speed.

Syntax: (config-int-eth-{n})# speed {10|100|auto}

Example: (config-int-eth-1)# speed 100

Supported Platforms:

Adit 3104, Adit 3200, Adit 3500, MSR

tos

Use the Ethernet Interface tos command to configure IP TOS marking. To disable TOS marking, see no

tos ip command on page 11-23.

Syntax: (config-int-eth-{n})# tos ip {enable|value hex-value}

Example: (config-int-eth-1)# tos ip value 0xff

Supported Platforms:

Adit 3104, Adit 3200, Adit 3500, MSR

Field Definition

10 10 Mbps speed .

100 100 Mbps speed.

auto Auto-negotiate the speed for the interface. Default.

Note: Setting speed to auto will set the duplex to auto.

Field Definition

enable Enable IP TOS marking.

hex-value Hex value, range 0x00-0xFF, default is 0x00

1 2 ... 264 265 266 267 268 269 270 271 272 273 274 ... 495 496

Komentáře k této Příručce

Žádné komentáře

Carrier-access Adit 3000 Series and Multi-Service Router (MSR) Ca Uživatelský manuál Strana 269

Komentáře k této Příručce

Související produkty a manuály pro Hardware Carrier-access Adit 3000 Series and Multi-Service Router (MSR) Ca