Carrier-access Adit 3000 Series and Multi-Service Router (MSR) Ca Uživatelský manuál stáhnout pdf (Strana 230)

100

101

9-2 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI

Configuration - Dial Peer Trunk Mode

codec preference

Use the Dial Peer codec preference command to set the codec preferences used to establish the codec

list offered during media negotiation. To delete a preference, see no codec preference command on

page 9-6.

Syntax: (config-dpeer-trk)# codec preference {1|2|3} {g711alaw|

g711ulaw|g729}

Example: (config-dpeer-trk)# codec preference 1 g711alaw

Supported Platforms:

Adit 3500, MSR

destination-pattern

Use the Dial Peer destination-pattern command to assign dial patterns to the trunk. To delete a pattern,

see no destination-pattern command on page 9-6.

Syntax: (config-dpeer-trk)# destination-pattern dest-pattern

Example: (config-dpeer-trk)# destination-pattern 555$

Supported Platforms:

Adit 3500, MSR

Field Definition

1|2|3 Enter the preference number. #1 being the first preference.

g711alaw Set the codec preference to G.711 A-law.

g711ulaw Set the codec preference to G.711 U-law.

g729 Set the codec preference to G.729.

Field Definition

dest-pattern Enter the phone number pattern that must be matched for calls to be

routed to the trunk. Use ? as a wildcard that can be replaced with any

single digit. Use $ as a wildcard that can be replaced with multiple

digits (all digits following the $ are ignored).

1 2 ... 225 226 227 228 229 230 231 232 233 234 235 ... 495 496

Komentáře k této Příručce

Žádné komentáře

Carrier-access Adit 3000 Series and Multi-Service Router (MSR) Ca Uživatelský manuál Strana 230

Komentáře k této Příručce

Související produkty a manuály pro Hardware Carrier-access Adit 3000 Series and Multi-Service Router (MSR) Ca